![]() ![]() I have found little in the way of solutions to try online and this is making me crazy. This issues has been going on for months now and it seems to be getting worse. I updated the ReadyNAS firmware about a month ago and no help.Īll the Desktops are running AVG Internet Security. I have deleted the user's account out of the ReadyNAS and built a new one.Īll the permissions in the ReadyNAS give the user full access to the folders being used. I have reset the permissions int eh ReadyNAS many times. The user account was a standard account but I deleted it and made a new account on the desktop as an admin account. If I log in to my admin account and try to move the files I also sometime run in to this issue. The documents are being scanned on the same machine and have the permissions. For example if the user make a new folder and scans five documents as five separate PDF's only two of the PDF's will copy over to the new folder. This issues comes up in different sub folders in the same root folder and seems to be very random. This office is receives new files all the time and build new folders all the time for them. I have a Netgear ReadyNAS at a location that is not allowing a use to copy some files to some folders. Loading configuration from /etc/fancontrol. What should be the path to your fancontrol config file (/etc/fancontrol)? The fancontrol script can automatically respond to temperature changesĭo you want to set up its configuration file now (y)? Please verify that all fans have returned to their normal speed. There is either no fan connected to the output of hwmon2/pwm5, There is either no fan connected to the output of hwmon2/pwm3, The pwm outputs connected to the fan connectors,ĭid you see/hear a fan stopping during the above test (n)? Or the connected fan has no rpm-signal connected to one of There is either no fan connected to the output of hwmon2/pwm1, ![]() Would you like to generate a detailed correlation (y)? n If you do not want to do this hit control-C now!!! This may cause your processor temperature to rise!!! Warning!!! This program will stop your fans, one at a time, Hwmon2/fan2_input current speed: 2621 RPM Hwmon1/fan1_input current speed: 4635 RPM Giving the fans some time to reach full speed. Hwmon2/pwm5 is currently setup for automatic speed control. Hwmon2/pwm4 is currently setup for automatic speed control. Hwmon2/pwm3 is currently setup for automatic speed control. Hwmon2/pwm2 is currently setup for automatic speed control. You want to setup this output for manual control? (n) y It is more efficient and it reacts faster. In general, automatic mode is preferred over manual mode, as Hwmon1/pwm1 is currently setup for automatic speed control. Physically verify that the fans have been to full speed However, it is ** very important ** that you ![]() The program will attempt to restore each fan to full speedĪfter testing. We will attempt to briefly stop each fan using the pwm controls. Note that many motherboards do not have pwmĬircuitry installed, even if your sensor chip supports pwm. This program will search your sensors for pulse width modulation (pwm)Ĭontrols, and test each one to see if it controls a fan on # Configuration file generated by pwmconfig, changes will be lost THE ETC/FANCONTROL FILE (AFTER RUNNING PWMCONFIG) Thank you so much for your help and time! Please help me identify my mistakes so that the etc/fancontrol file actually has entries. I tried getting help from Arch-Wiki but there the pwmconfig process is not further explained. I ran $ sudo sensors-detect then sudo pwmconfig (the process of pwmconfig is shown down below) and now wanted to modify the fancotrol file (also copy pasted down below) so that the fans only work at high temperatures, but unfortunatly the does not have any pairs of fans and pwms anywhere, so that it is useless. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |